Scroll saw sanding belt, width 7 mm, without cross bar

4 pieces of stable grinding belts coated with aluminum oxide for clamping in the saw blade holder of scroll saws in various grit sizes

Please choose the desired grit!

For easy and fast sanding of edges or deburring of fine scroll saw work.
Width: 1/4" (7 mm)
Make sure that the saw table has a sufficiently large passage (min. 5 x 10 mm) so that the sanding belts do not rub against the saw table when working.
Suitable for scroll saws with 130 mm (5") saw blade length.

The sanding belts fit most 130 mm scroll saws (Hegner®, Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but depending on the width of the sanding belt used, modifications to the blade mount or table opening may be required. Be sure to check the table/stitch plate opening before purchasing a sander.

Machines suitable for cross-bar sanding belts:
Hegner®
Delta® (Trim or remove table opening)
Dremel® 1670, 1671 & 1680 (Remove plastic hood on saw blade clamp to clamp sanding belt.)
DeWalt® (only suitable for the 7mm sanding belts unless you drill the table hole larger.)
Excalibur® (suitable only for the 7 mm sanding belts, unless you drill the table opening larger.)
Ryobi® SC 160

Machines suitable for sanding belts without a crossbar:
Hegner®
DeWalt® (suitable only for the 7 mm sanding belts, unless you drill the table opening larger.)
Excalibur® (only suitable for the 7mm sanding belts unless you drill the table opening larger.)
Ryobi® SC 162, 162VS & 165

The sanding belts will not fit RBI®, Reliant® or Moto-Shop®.