Scroll Saw Sanding Belt, Width 7mm, with crossbar

4 pieces of aluminium-oxide-coated, stable sanding belts for hanging in scroll saws in different grit sizes

Please select the desired grit size!

• Width: 1/4" (7mm)
• Make sure that the saw table has a sufficiently large passage (at least 5 x 10mm) so that the sanding belts do not grind on the saw table when working.
• For quick and easy sanding of edges or deburring of fine scroll saw work
• Suitable for scroll saws with 130mm (5") saw blade length

The sanding belts can be used in all scroll saws that have a mounting bracket (above and below), as shown in the picture below.

Fits most 130 mm scroll saws (Hegner®, Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.

Machines suitable pin end sanders
Hegner®
Delta® (cut table insert to fit sander, or remove table insert)
Dremel® 1670, 1671 & 1680 (Remove nub of plastic at gate to fit into clamp, if necessary.)
DeWalt® (only accept the 7 mm sanders unless you drill the table hole larger.)
Excalibur® (only accept the 7 mm sanders unless you drill the table hole larger.)
Ryobi® SC 160

Machines suitable plain end sanders
Hegner®
DeWalt® (only accept the 7 mm sanders unless you drill the table hole larger.)
Excalibur® (only accept the 7 mm sanders unless you drill the table hole larger.)
Ryobi® SC 162, 162VS & 165

The sanders do not fit RBI®, Reliant® or Moto-Shop®