Prices incl. VAT plus shipping costs
only 4 in stock available immediately
Order within7 minutes this and other products.
- Order number: 001220.1
SALE!
The collets are NOT included in the scope of delivery of the chuck. The two clamping pins are also not included in the scope of delivery.
Collets in the range from 2 mm to 20 mm are available.
This collet chuck has been specially developed for wood turners. With the precise collets, the workpiece is clamped exactly evenly over a length of 40 mm without leaving any marks. The clamping path is 1 mm. If a hollow spindle is available through which the wood can be fed, the chuck is well suited for series production of small turned parts, as the chuck is also hollow throughout.
The chuck has an M33 x 3.5 mm spindle thread.
General information on collet chucks:
- The clamping dimension specification (e.g. 6-5 mm) means that round workpieces or tools with a diameter of 5 to 6 mm can be clamped.
- Collet chucks must always be kept very clean. Chips or other dirt particles significantly impair the clamping force and concentricity of the chuck.
- Collet chucks should never be screwed together without a workpiece (or tool).
- Collet chucks should never be stored with the collet inserted.
- No workpieces or tools below the small clamping range diameter should be clamped.
- Workpieces or tools should be clamped as completely as possible, but at least to 2/3 of the bore length of the collet chuck.
Dimensions:
Total length of chuck: 78 mm
Ø knurled union nut: 58 mm
Ø thread (union nut) / smallest Ø: 40 mm
Ø "rear knurled ring" - 53 mm
Length from front edge knurled nut to rear knurled ring: 63 mm
Width of knurled union nut: 25 mm
Width of rear knurled ring: 14 mm