Mandrel set in case, adjustable length

Comprehensive starter set for pin turning

A pin mandrel is very useful for clamping pin blanks or similar workpieces in the lathe. The mandrel is fitted with an 1MT or 2MT morse taper. It is held on the tailstock side with the centre punch point running with it. The workpiece is clamped with a brass knurled nut. Cylindrical spacer bushes can be used to clamp blanks of various lengths. Additional spacer rings are available.
The mandrel is adjustable in length and has a diameter of 6.2mm (mandrel diameter) and is therefore suitable for almost all commercially available pin kits.

The case set contains:

• Length-adjustable mandrel with 1MT or 2MT receptacle (Please select!)
• 3 parallel sleeves
• 4 conical sleeves
• Face milling cutter for the pen blanks
• 5 biros kits with refill (see also these kits...)
• 3 drills with diameters 6.8 / 6.9 and 7mm
• Allen key and open-end spanner

Please note that you will need a cannulated spindle to accommodate this mandrel in order to be able to knock out the Morse taper again.

With maximum utilisation of the length adjustment, the distance between the knurled nut (without lock nut) and the Morse taper receptacle body is approx. 170mm.